Panasonic PTL-701/711 Directions

1. Connect your laptop to the projector using the Computer Video cable. Connect one end to the projector input “RGB 1 IN” and the other end to your laptop.

2. Remove the lens cap.

3. Turn on the projector’s “MAIN POWER” switch near the rear left (this turns on the main power and cooling fan)

4. Press the “POWER” button on the top control panel ONCE (this turns on the projection lamp - Wait: it takes about 20 seconds for the lamp to warm up)

5. Press “INPUT” to select the laptop computer (“RGB1” appears on screen).

6. Power up your laptop. The image should appear on the projector.

7. Adjust the height of the projected image with the height adjustment lever near the lens at the front of the projector.

8. Adjust the picture size and focus with the ring and lever at the projector lens.

9. Push the “AUTO SETUP” button. This will fix any key-stoning problems.

10. No Image? Press “INPUT” to make sure you are on “RGB1”. Also, you may have to adjust your laptop’s settings to get the image onto the projector. On a PC use the FUNCTION-F key combination (look for a little TV screen, “LCD” or “display” on the function keys). On a MAC laptop you may have to “arrange the monitors” and/or turn on video mirroring in the control strip.

Turning off (very important)

1. Press the “POWER” button on the projector’s top control panel TWICE. (This turns off the projection lamp)

2. Replace the lens cap.

3. Wait until the cooling fan stops (about 2 minutes).

4. While you are waiting, shut down the laptop computer power

5. After confirming that the projector cooling fan has stopped, turn off the “MAIN POWER” switch on the side, near the projector’s power cord.

6. It is now safe to unplug the power. Return cables and projector to carrying case.

Problems? Call HCAV at 610-896-1193

HCAV 1/03 PTL-701/711

STOP!

Remove the lens cap before turning on the projector!

If you leave it on it will MELT!

· The lens cap must be removed before turning on the projection lamp.

· Do not replace it until the lamp has been turned off.

Put away the cables!

· Please properly coil both the power cord and the video cable and return them to the front pocket on the carrying bag.

^{Read the directions on reverse!}